Ai HSB524 2006-2012 Honda Speaker Adaptor

6 reviews for Ai HSB524 2006-2012 Honda Speaker Adaptor

1. 

   Rated 5 out of 5

   – February 15, 2024 Dr. Julius Dicki DDS

   I was not sure if this item would work on my car, but I am glad I ordered it. This item works on my 2023 Honda Civic. (Fits Front and Rear Doors) The only thing I would say is that I wish it had a solid flat base so the foam tape I purchased separately has a flat surface to stick too. Otherwise, this worked perfectly and saved me a lot of time. Mine even came with hardware.

2. 

   Rated 5 out of 5

   – February 17, 2024 Dr. Lillie Collier III

   I used these in a 2013 Honda Pilot. I replaced the stock speakers with aftermarket 6.75″ coaxial speakers. The screw holes were not an exact perfect fit for either pair of speakers that I have (Alpine and JVC), but were close enough to get the job done.

3. 

   Rated 5 out of 5

   – May 26, 2024 Yadira Goldner

   These were easy to install and were a perfect fit for my Civic.

4. 

   Rated 5 out of 5

   – October 6, 2024 Amina Considine

   very good

5. 

   Rated 5 out of 5

   – October 16, 2024 Miss Karelle Connelly I

   Installed in my 2009 Honda CRV. I had to modify them to work with the new Rockford Fosgate 6.5 in speakers by cutting the inner tabs out and then drilling holes in the plastic to match up with the speaker mounting holes, no big deal. I was able to use speaker mounting tape on the underside by just applying it to the both narrow strips of plastic. Seemed to seal to door as it should. Speakers sound great with these.

6. 

   Rated 5 out of 5

   – October 23, 2024 Dr. Gregory Corkery IV

   Needed to replace my 2007 Honda Civic Speakers and they have these hook and single bolt construction designs in both the door and the back seats. I didn’t want to have to deal with the challenge of possibly drilling holes when seating new speakers so I went with these. They just worked great.I used some JVC 6” speakers, took the grills off, and then attached them to these supports. One hole aligned cleanly, the others (2 locations) I pre drilled a hole to attach the speaker to the tabs and then screwed them down solid. They were secure and ready to mount. Took the panel off my door, removed the old speakers, connected the new speakers, aligned the two tabs to slide the speaker in the door and reattached the primary securing screw. Was able to install both door speakers in less than 30 minutes and I’ve never worked with car audio before.If you want your install to get a little easier when replacing your speakers with ones that aren’t Honda branded and you have one of these Civic models, this will definitely save you time and make the install a lot easier and more secure without having to modify the door hardware. Recommended!!!